NEC ipasolink 400 - Idu Configurations

22
IDU CONFIGURATIONS
Table 6 lists the available plug-in unit options.
Type number
Name
Description
NWA-055298-001
MC-A4
Control unit with
16E1(MDR) + 2GbE(RJ45)+ 2GbE(SFP) – mandatory
NWA-055300-xxx*)
MODEM-A
Modem can be installed in universal slots 1 to 4, optional.
TNC connector (female) for the ODU-cable. Grounding connector.
Modem power switch. XPIC-connectors. 512QAM supported HW-
version 2.00 and later
NWA-055303-001
NWA-055303-101
GbE-A
2GbE(T) + 2GbE(SFP) interface card for slots 1 to 4, optional
NWA-060926-002-01
Sumitomo SCP6G44-GL-
CWH
LX SFP
LX SFP Module 1000 Mbit/s
NWA-060926-003-01
Finisar FCLF8521P2BTL
GbE T (TRI) SFP
Electrical GbE (TRI-MODE) SFP: 10/100/1000 BASE-T
NWA-055294-001,-002
FAN-C
Fan unit, mandatory
NWA-055310-001
PS-A4
Power supply unit (one mandatory, second optional)
CBE-009983-001,-003
136147-3
SFP-port protecting plug
NWM-034915-001
BLANK COVER
Universal Slot blank cover (mandatory when Universal Slot empty)
NWM-034910-001
BLANK COVER
Power Supply blank cover (mandatory when PS not installed in slot)
NEC-XCB-1023-0,4
XPIC CABLE
XPIC cable 40 cm, two cables per XPIC modem pair
NWA-055302-001
NWA-055302-101
16E1-A
16 x E1 interface card for universal slots 1 to 4, optional
NWA-055304-004
NWA-055304-104
STM1-A
STM-1 interface card for universal slots 1 to 4
Optical Interface(S-1.1)/(L-1.1) or Electrical G.703, optional
NWA-055306-001
MSE-A
PWE-card for universal slots 1 to 4, optional. For transporting E1 over
Ethernet packets.
NWA-055307-001
AUX-A
Additional interfaces (ALM, EOW, NE2) , for universal slots 1 to 4,
optional.
NWA-055289-002
CLK2M-C
Clock module, installed on the MC-A4 card, required for Synchronous
Ethernet and SDH-demultiplexing. Optional. Can be retrofitted in the
field.
Table 6. IDU cards
*) xxx = 001 (discontinued); 202 = ASIC version; 102 = PRTA version (required for L1 physical Radio Traffic Aggregation); 322 =
unified version, available 9/2012.
Limitation: the SFP modules installed in each MC-A4, GbE-A or STM1-A SFP port have to be identical or
the right port empty. Third party SFP modules do not generate an alarm (note: FW version dependent)
but correct operation is guaranteed only for an SFP delivered by NEC.