82
PORT QOS SETTINGS
The settings for the QoS policy example are described here.
Table 16 shows one-to-one mapping from CoS to internal priority which is the default setting in the Port
Based QoS Mode and cannot be changed in this mode. The settings for each ingress port have to be
modified: mapping from internal priority to egress queue class, scheduling, shaping and WRED-settings.
Figure 73. QoS Port Setting List.
The egress port queuing class for each ingress frame is set based on the ingress port and the internal
priority in tab Port Setting.
The summary page right side Class Info /Detail link opens the Egress Class Detail settings for that port
(Figure 74). Further, the Class number link opens the Egress Class Setting (Figure 75). The Port-link on the
summary page (Fig. 73) opens the port settings (Figure 76).
Figure 74. Summary of the port Egress settings. Edit each class settings using the link.
To Next Page
Loading...
