NEC M353WS - Setting up the Projector for a Wired LAN Connection [WIRED LAN]

109
5. Using On-Screen Menu
Setting up the Projector for a Wired LAN Connection [WIRED LAN]
Important
• Consultwithyournetworkadministratoraboutthesesettings.
• WhenusingawiredLANconnection,connectaLANcable(Ethernetcable)totheLANport(RJ-45)oftheprojec-
tor.(→page128)
TIP:Thenetworksettingsyoumakewillnotbeaffectedevenwhen[RESET]isdonefromthemenu.
[WIREDLAN] [DISABLE] WiredLANconnectionwillbeturnedoff.
[ENABLE] WiredLANconnectionwillbeturnedon.
[SETTINGS] [DHCP]
ON
�������������������������� IP address, subnet mask, and gateway will
be automatically assigned to the projector
from your DHCP server�
OFF ������������������������� Specify IP address, subnet mask, and gate-
way assigned by your network administra-
tor�
[IPADDRESS] Set your IPaddressof the networkconnected to the
projector.
[SUBNETMASK] Setyoursubnetmasknumberofthenetworkconnected
totheprojector.
[GATEWAY] Setthedefaultgatewayofthenetworkconnectedtothe
projector.
[AUTODNS]
ON �������������������������� DHCP server will automatically assign IP
address of DNS server connected to the
projector�
OFF ������������������������� Set your IP address of DNS server connected
to the projector�
[RECONNECT] Retrytoconnecttheprojectortoanetwork.