NEC ME401X - ❼ Optimizing Computer Signal Automatically; Adjusting The Image Using Auto Adjust; ❽ Turning Up Or Down Volume

20
2. Projecting an Image (Basic Operation)
❼ Optimizing Computer Signal Automatically
Adjusting the Image Using Auto Adjust
Optimizingacomputerimageautomatically.(COMPUTER)
PresstheAUTOADJ.buttontooptimizeacomputerimageautomatically.
Thisadjustment may benecessary whenyou connect your computer
forthersttime.
[Poor picture] [Adjusted picture]
NOTE:
Somesignalsmaytaketimetodisplayormaynotbedisplayedcorrectly.
• IftheAutoAdjustoperationcannotoptimizethecomputersignal,trytoadjust[HORIZONTAL],[VERTICAL],[CLOCK],and[PHASE]
manually.(→page62,63)
❽ Turning Up or Down Volume
Soundlevelfromthespeakeroraudiooutputcanbeadjusted.
TIP:Whennomenusappear,the◀and▶buttonsontheprojector
cabinetworkasavolumecontrol.
NOTE:
• Volumecontrolisnotavailablewiththe◀or▶buttonwhenan
imageismagniedbyusingtheD-ZOOM(+)buttonorwhenthe
menuisdisplayed.
• Volume controlisnot available with the◀ or▶button when
VIEWERisused.
TIP:The[BEEP]soundvolumecannotbeadjusted.Toturnoffthe
[BEEP]sound,fromthemenu,select[SETUP]→[OPTIONS(1)]→
[BEEP]→[OFF].
Increasevolume
Decrease volume