38
5. Using On-Screen Menu
[ECO mode]
Change lamp brightness according to the environment and aim your projector is operating.
1) Press ▲ ▼ button to select [ECO mode] menu.
2) Press <ENTER> button.
3) Press ▲ ▼ button to switch required menu.
Normal.....Normal brightness.
ECO 1/ECO 2........Lower the brightness and reduce energy consumption, thus prolonging the light source service life.
Boost.......Enhance brightness.
On start
HDMI setup
Setting
Standby mode
High altitude
ECO mode
Cooling fast
Closed caption
Key lock
lris
Baud rate
Sound
Off
Normal
Normal
Off
Normal
Off
Off
Off
19200
[Cooling fast]
Select the cooling time after projector is turned off.
1) Press ▲ ▼ button to select [Cooling fast] menu.
2) Press <ENTER> button.
3) Press ▲ ▼ button to switch required menu.
Normal............Running in normal way.
30 Sec.....Running faster than in normal mode with shorter time but a louder sound.
0 Sec.......Select this function allow you to unplug the AC power directly after the shutdown, without waiting for the
projector cooling off.
NOTE:
• When set the option 0 Sec, user cannot restart the projector immediately after turning off it.
• While sometimes,the lamp may take a longer time to cool off than usual to light again for high temperature.
On start
HDMI setup
Setting
Standby mode
High altitude
ECO mode
Cooling fast
Closed caption
Key lock
lris
Baud rate
Sound
Off
Normal
Normal
Off
Normal
Off
Off
Off
19200
To Next Page
Loading...
