Problem Check These Items
Picture is fuzzy Adjust the Brightness, then Contrast Controls.
Access the Degauss Control through OSM.
Activate the Degauss Control. CAUTION: A
minimum interval of 20 minutes should exist
before the Degauss Function is used a second time.
Picture bounces or a
waving pattern is
present in the picture
Move electrical devices that may be causing
electrical interference away from the monitor.
Edges of the display
image are not square
Use the OSM Geometry Controls to straighten the
edges.
Display image is not
centered, too smaIl, or
too large
Use the OSM Size and Position controls to adjust
the image.
Color looks blotchy Adjust the Brightness, then Contrast Controls.
Access the Degauss Control through OSM.
Activate the Degauss Control. CAUTION: A
minimum interval of 20 minutes should exist
before the Degauss Control is used a second time.
Specifications
Picture Tube E500: 38 cm (15 inch) flat square CRT, 35 cm (13.8 inch)
viewable image size,
E
700
:
43 cm (17 inch) flat square CRT, 39.6 cm (15.6 inch)
viewable image size,
0.25 mm mask pitch, Medium-Short persistence
phosphor, dark tint screen, CROMACLEAR CRT with
multi-layered, anti-static OptiClear coating
Input Signal Video Analog 0.7 Vp-p 75 Ω Positive
Sync Separate sync.
Horizontal sync.
Vertical sync.
Composite sync.
TTL Level
Positive/Negative
Positive/Negative
TTL Level
Positive/Negative
E - 14 Specifications
To Next Page
Loading...
Need help?
General