English - 56
CRESTRON CONTROL Settings
Click on “CRESTRON CONTROL” on the left column below HOME.
CRESTRON CONTROL
Enables or Disables managing from the controller.
CONTROLLER IP ADDRESS Sets the IP address of the CRESTRON SERVER.
IP ID Sets your CRESTRON SERVER IP ID.
PORT Sets the Crestron port used for Ethernet communication.
HINT The CRESTRON CONTROL settings are required only for use with Crestron’s ROOMVIEW.
For further information, visit https://www.crestron.com
AMX Settings
Click on “AMX” on the left-hand column on the HOME screen to enter the setting screen.
AMX BEACON
When the monitor is connected to a network supporting the NetLinx control system by AMX, enables or
disables the function to send a beacon to the system from AMX Device Discovery.
NOTE When using a device that supports AMX Device Discovery, all AMX NetLinx control systems will recognize the
device and download the appropriate Device Discovery Module from an AMX server.
To Next Page
Loading...
