NEC MultiSync XV2930

5
SPECIFICATIONSSPECIFICATIONS
1. Cathode ray tube
a. tube size 29 inch (27 inch viewable)
b. Dot pitch H=0.74mm, V=0.64mm
c. Light transmission 49% typical
2. Power
a. Input voltage 120 Vac ~ 60Hz
b. Input current 2 A at 120 Vac / 60Hz
c. Inrush current 50A
d. Power consumption 240 Watts (Max)
e. Line regulation 95 to 145 Vac / 60Hz
3. Input signal
Video signal
a. Type Analog
b. Polarity Positive
c. Amplitude RGB: 0.7 Vp=p/AV: 1 .O Vp-p
d. input impedance 75 ohms
e. Dot rate 50MHz(max.)
Horizontal sync
a. Type TTL
b. Polarity positive or negative
c. Input impedance 1 K ohm (Min)
d. Frequency RGB: 31 KHz to 38 KHz
Video: 15.734 KHz (NTSC) / 60Hz
Vertical sync
a. Type TTL
b. Polarity positive or negative
c. Input impedance 1 K ohm (Min)
d. Frequency 50 Hz. To 90 Hz.
4. Connector type
15 pin D-type, RCA JACK and S-Video terminal
5. Pin assignments for D-type connector
Pin 1: RED Pin 6: RED RETURN Pin 11: GND
Pin 2: GREEN Pin 7: GREEN RETURN Pin 12: SDA
Pin 3: BLUE Pin 8: BLUE RETURN Pin 13: H-SYNC
Pin 4: GND Pin 9: NC Pin 14: V-SYNC
Pin 5: GND Pin 10: GND Pin 15: SCL