NEC NP-CR5450H - Page 23

23
7. NETWORK SETTINGS
Advanced settings (simple access point)
Item Description Remarks
WPS settings Select the WPS push button method.
• Disable:DisabletheWPSfunction.
• Pushbutton:SelecttheWPSpushbuttonmethod.WPS
push button will be displayed in the application menu.
Security setting Select the security type (WPA2-PSK).
• The defaultfactory setting
whenshippedis“Disable”.
• TheWPA2-PSKkeyconsists
of 8 - 63 half-byte alphanu-
meric characters.
SSID
SettheSSID. This consists of 1 - 32 half-byte
alphanumeric characters. The
default factory setting is the
manufacturing number of this
device.
LANmode Choose the wireless mode. The default factory setting when
shippedis“IEEE802.11b/g/n”.
Channel Choose the wireless channel. The default factory setting when
shippedis“6”.
Connection method with the push button method
1. Press the WPS push button under the application menu of the projector (AP).
A countdown of the WPS appears in the application menu.
2. Press the WPS push button on the WPS supported wireless terminal (Client side) during the countdown.
The WPS supported wireless terminal (Client side) will connect to the projector (AP).
Advanced Settings (Wi-Fi Direct)
Item Description Remarks
WPS settings Select the WPS push button method.
• Autopushbutton:Enabletoomittheproceduresearching
theterminalwhenreceivingconnectionrequestfromthe
Wi-FiDirectsupportedwirelessterminal.
• Push button: Perform the procedure foraccepting the
connectionrequestreplyfromtheWi-FiDirectsupported
wireless terminal.
The default factory setting when
shippedis“AutoPushButton”.
How to connect with the auto push button method
1. Perform to search the Wi-Fi Direct supported device on the Wi-Fi Direct supported wireless terminal.
2. Select the projector name (this device) that is displayed in the search results.
The Wi-Fi Direct supported wireless terminal will connect to this device.
How to connect with the push button method
1. Display the APPS MENU screen on the projector.
2. Perform to search the Wi-Fi Direct supported device on the Wi-Fi Direct supported wireless terminal
3. Select the projector name (this device) that is displayed in the search results.
Countdown for connection request will appear on the APPS MENU of the projector
4. Press the accept button of the connection request reply dialog box during the countdown.
The Wi-Fi Direct supported wireless terminal will connect to this device.