NEC NP-CR5450H - Page 24

24
7. NETWORK SETTINGS
Advanced settings (Miracast)
Item Description Remarks
WPS settings Select the WPS method.
• Autopushbutton:Enabletoomitthesearchingprocedure
whenreceivingtheconnectionrequestfromtheMiracast
supported wireless device.
• Pushbutton:Performthesearchingproceduretoaccept
theconnectionrequestreplyfromtheMiracastsupported
wireless device.
• PINcode:InputthePIN codeindicatedontheprojector
onto the Miracast supported wireless device.
The default factory setting when
shippedis“AutoPushButton
HDCPsetting ChoosethefunctionofcontentsprotectionbyHDCP.
• Disable:DoesnotsupportHDCP
• Enable:SupportHDCP
The default factory setting when
shippedis“Enable”.
This projector supports
HDCP2.2.
How to connect with the auto push button method
1. Perform to search a Miracast supported device (receiver side) on the Miracast supported wireless terminal
(sender side)
2. Select the projector name (this device) that is displayed in the search result.
The connection between the projector and the Miracast supported wireless terminal (sender) will be established
and start the Miracast transmission.
How to connect with the push button method
1. Display the APPS MENU of this projector.
2. Perform to search a Miracast supported device (receiver side) on the Miracast supported wireless terminal
(sender side)
3. Select the projector name (this device) that is displayed in the search result.
Countdown for requesting the connection will appear on the APPS MENU of this device.
4. button during the countdown
The connection between the projector and the Miracast supported wireless terminal (sender) will be established
and start the Miracast transmission.
How to connect with the PIN code method
1. Display the APPS MENU of this projector.
2. Perform to search a Miracast supported device (receiver side) on the Miracast supported wireless terminal
(sender side)
3. Select the projector name (this device) that is displayed in the search result.
Countdown for requesting the connection will appear on the APPS MENU of this device.
4. button during the countdown
The connection between the projector and the Miracast supported wireless terminal (sender) will be established
and start the Miracast transmission.