29
■ Setting Wired LAN
1
Display the “WIRED” page of “NETWORK SETTINGS”.
Configure the setting of wired LAN in the “WIRED” page of “NETWORK SETTINGS” selected from
On-Screen Menu. If “NETWORK SETTINGS” is not displayed, refer to “4-1. Displaying On-Screen
Menu (NETWORK SETTINGS)” ( page 17).
2
Select “PROFILES”.
“PROFILE 1” or “PROFILE 2” can be stored in the memory of the projector as the setting of LAN.
<1> Press the
SELECT
button once to highlight the “PROFILES” field and press the
button.
<2> Use the
SELECT /
button to highlight “PROFILE 1” or “PROFILE 2”, and press the
button.
3
Set “DHCP”.
Follow the same procedure as in “4-2. Wireless LAN” ( page 19).
4
Input “IP ADDRESS”, “SUBNET MASK”, and “GATEWAY”.
Follow the same procedure as in “4-2. Wireless LAN” ( page 19,20).
5
Input “DNS CONFIGURATION”.
Follow the same procedure as in “4-2. Wireless LAN” ( page 20).
6
Reconnect the network.
<1> When all the above items have been input or set, use the
SELECT /
button to highlight
“RECONNECT” and press the button.
7
Finalize the setting.
<1> Use the button to highlight [OK] and press the button.
The setting will be stored in the memory of the projector.
4. Setting the LAN Setting of Projector
Setting the LAN Setting of Projector
4
NP3150NWSETUP-01.pm65E 9/26/07, 11:14 AM29
To Next Page
Loading...
