To Next Page

To Previous Page

Important Information

About High Altitude mode

• Set [FAN MODE] to [HIGH ALTITUDE] when using the projector at altitudes approximately 5500 feet/1700 meters

or higher.

Using the projector at altitudes approximately 5500 feet/1700 meters or higher without setting to [HIGH ALTITUDE]

can cause the projector to overheat and the protector could shut down. If this happens, wait a couple minutes and

turn on the projector.

• Using the projector at altitudes less than approximately 5500 feet/1700 meters and setting to [HIGH ALTITUDE]

can cause the light module to overcool, causing the image to icker. Switch [FAN MODE] to [AUTO].

• Using the projector at altitudes approximately 5500 feet/1700 meters or higher can shorten the life of optical com-

ponents such as the light module.

Light Module

1. A light module containing multiple laser diodes is equipped in the product as the light source.

2. These laser diodes are sealed in the light module. No maintenance or service is required for the performance of

the light module.

3. End user is not allowed to replace the light module.

4. Contact qualied distributor for light module replacement and further information.

Laser Safety Caution

• For USA

This product is classied as Class 3R of IEC 60825-1 Second edition 2007-03

Complies with FDA performance standards for laser products except for deviations pursuant to Laser Notice No.

50, dated June 24, 2007.

For other regions

This product is classied as Class 1 of IEC 60825-1 Third edition 2014-05 and RG2 of IEC 62471-5 First edition

2015-06.

Obey the laws and regulations of your country in relation to the installation and management of the device.

• Outline of laser emitted from the built-in light module:

• Wave length: 455 nm

• Maximum power: 140 W (PA703UL/PA653UL), 168 W (PA803UL)

• Radiation pattern from the protective housing:

• Wave length: 455 nm

• Maximum laser radiation output: 333 mW

• The laser module is equipped in this product. Use of controls or adjustments of procedures other than those speci-

ed herein may result in hazardous radiation exposure.

CAUTION

• Use of controls or adjustments or performance of procedures other than those specied herein may result in

hazardous radiation exposure.

CAUTION – CLASS 3R OF IEC 60825-1 SECOND EDITION LASER PRODUCT

LASER LIGHT – AVOID DIRECT EYE EXPOSURE

NEC PA803UL User Manual

Other manuals for NEC PA803UL