Selecting the Input Signal Source
Basic Operations (Continued)
1
2
3
Press Source button.
Press OK or Source button to confirm the selection.
Press 6or 5to select the input source.
Options include:
! TV — Watch the TV signal.
! AV1 — Watch the signal from the AV1 input terminals.
! AV2 — Watch the signal from the AV2 input terminals.
! S-Video — Watch the signal from the S-VIDEO input terminal.
! YPbPr1 — Watch the signal from the COMPONENTinput 1 terminals.
! YPbPr2 — Watch the signal from the COMPONENTinput 2 terminals.
! D-Sub — Watch the signal from the D-SUB jack.
! HDMI — Watch the signal from the HDMI input jack.
=
You can also make use of OSD main menu (System menu)to select the input source.
You can quickly go to first item (TV )and last item (HDMI) by pressing 3or4button.
Note
Displaying the Information Banner
Press the Info button to display the information banner. The information banner displays current status information such as
the channel number and signal source.
Depending on the mode, different information is displayed. In DTV mode, more information will be displayed. Below is an
example banner in DTV mode.
=
The above OSD is only served as an example, and it is in DTV mode.
=
Information banner content varies, depending on the broadcaster and your settings.
Note
In DTV mode, the information banner may contain:
! Channel number and name.
! Current time.
! Current program name, start and end play times.
! Next program name and start and end play times.
! TV or Radio.
! Audio mode (stereo or mono), audio track.
! Signal strength for current channel.
! Signal resolution.
! Program rating, etc.
Source
1. TV
2. AV1
3. AV2
4. S-Video
5. YPbPr1
6. YPbPr2
7. D-Sub
8. HDMI
Select
OK
First/Last
Video Audio Setup Rate System Display
Source
State
TV
NSW/ACT
7
007 7 Digital 15:13
STEREO
English
Signal Strength 95%
Digital
SD Stereo
TV
SUB
TTX
BLUE HEELERS
PASSIONS
15:00-15:59
16:00-16:59
576i
G
AC3
15
To Next Page
Loading...