⁄DHeating Operation Mode (Heat pump model only)
( LED lamp ON)
— 12 —
2
Select Heating Operation.
Press the Operation Mode Selection Button.
Each time the button is pressed, the operation mode is shifted in the arrow direction.
3
Set the temperature.
4
Set the fan speed.
1
Press the Start/Stop Button.
• Two short beeps will sound and
the operation lamp will light up.
To raise the Temperature
To lower the Temperature
Beep, Beep
Operation Display
Cooling Operation
Soft Dry Operation
(Heat pump model only)
Heating Operation
Auto Operation
• The temperature can be set
within a range of 16°C~30°C by
1°C.
• Each time the button is pressed, the fan speed is altered.
• Select the fan speed in four steps
-low, medium, high, AUTO.
• The display shows high fan speed.
To Next Page
Loading...
