NEC RSC1711 - Indoor and Outdoor Unit Components

Force Operation Button
Use for operation when the remote controller cannot be used.
(When operation is stopped by the remote control without
removing power plug, the room air conditioner consumes
approximately 2W of electricity.)
Signal Receptor
Receives the signals from the remote controller.
(Signal receiving sound:two short beeps or one long beep.)
Operation Indication Lamps
On/Off : Lights up during the air conditioner
operation.
Sleep Mode : Lights up during Sleep Mode Auto
operation.
Timer : Lights up during timer operation.
Deice Mode : Lights up during Deice Mode operation.
(Blinks on and off during hot start)
- Heating Model only
Outdoor Unit : Lights up during the outdoor unit's
Operation operation.- Cooling Model only
(2) Indoor Unit, Outdoor Unit
— 4 —
Open the front panel
Pull the panel to
open(left and right side
of front panel) and open
the panel upward.
Outdoor Unit
Indoor unit controls
and indicators
Air Intake Vent
(front panel)
Indoor Unit
Air Outlet Vent
Horizontal Airflow
Direction Louver
Remote Controller
Storage
Power Supply Cord
Air Filters
(behind front panel)
Panel Opening
(left and right)
Air Intake Vents
Air Outlet Vent
(Side)
(Rear)
Drain Hose
Piping
Vertical Airflow Direction Louver
(The air outlet vent opens when the operation starts.)
OUT
DOOR