SOPHO IP 5000/SOPHO IP6000
Command Reference Guide 93
the interface-type. The source IP address for the NTP packets sent from the
local end to the server is got from this interface.
priority: Specifies the server as the preferred one.
Description
Using the ntp-service unicast-server command, you can configure the NTP
server mode. Using the undo ntp-service unicast-server command, you can
remove the NTP server mode.
By default, the version number is 3, ID authentication is enabled and the server
is not the preferred one.
This command is used to set the remote server specified by the X.X.X.X as the
local time server. The X.X.X.X is a host address and cannot be the IP address
of the broadcast, multicast or reference clock. In this configuration, the local
client device can be synchronized to the remote server and the remote server
cannot be synchronized to the local client device.
Example
Configure the local device to be provided with the synchronous time by the
server 128.108.22.44. The version number is 3.
[NEC-PHILIPS] ntp-service unicast-server 128.108.22.44 version 3
3.10 \SNMP Configuration Commands
debugging snmp-agent Syntax
debugging snmp-agent { header | packet | process | trap }
undo debugging snmp-agent { header | packet | process | trap }
View
User view
Parameter
header: Enables the debugging of packet information header.
packet: Enables the packet debugging.
process: Enables the process debugging of SNMP packets.
trap: Enables the debugging of Trap packets.
Description
Using the debugging snmp-agent command, you can enable the SNMP Agent
debugging and specify the debugging information of SNMP module. Using the
undo debugging snmp-agent command, you can remove the current settings.
By default, the SNMP Agent debugging is disabled.
Example
Enable the debugging of SNMP Agent packet information header.
<NEC-PHILIPS> debugging snmp-agent header
display snmp-agent Syntax
display snmp-agent { local-engineid | remote-engineid }
To Next Page
Loading...
Need help?
General
