NEC SOPHO IP 5000 User Manual

SOPHO IP 5000/SOPHO IP6000
Command Reference Guide 125
To count the traffic size on an interface within a specific period, you must clear
the existing statistics about the transmitted and received packets on the
interface before taking a new count.
For a related command, see display interface.
Example
Clear the statistics about the transmitted and received packets on Serial 0/0/0.
<NEC-PHILIPS> reset counters interface serial 0/0/0
shutdown Syntax
shutdown undo shutdown
View
Interface view
Parameter
None
Description
Using the shutdown command, you can shut down an interface. Using the
undo shutdown command, you can enable an interface.
This command takes effect not only on physical interfaces but also on tunnel
and MFR interfaces.
In some circumstances, such as when you are modifying the operating
parameters of an interface, the modification do not take effect immediately.
Rather, you must shut down the interface and re-enable it.
For a related command, see display interface.
Example
Shut down Ethernet 0/0/0.
[NEC-PHILIPS-Ethernet0/0/0]shutdown
% Interface Ethernet0/0/0 is down
% Interface Ethernet0/0/0 changed state to DOWN
% Line protocol ip on interface Ethernet0/0/0, changed state to DOWN
4.2 Fundamental Ethernet interface configuration commands
display interface ethernet Syntax
display interface ethernet interface-number
View
Any view
Parameter
interface-number: Interface number. If no interface has been specified, the
configuration and state information of all the interfaces will be displayed.
Description
Using the display interface ethernet command, you can view the configuration
parameters, current running state, and some other information of an Ethernet
interface.
Example
View the state information of the Ethernet interface 2/0/0.

NEC SOPHO IP 5000 Specifications

General

Brand	NEC
Model	SOPHO IP 5000
Category	Network Router
Language	English