Chapter 3 Operation Settings
120
If the RPL_WATCHDEV is not specified, the default is 5 seconds.
•
••
• Wait Process Termination Time
RPL_ENDWATCHDEV=second
If the -wait option of iSMrc_replicate, iSMrc_separate,iSMrc_restore,
iSMsql_snapshotbkup, and iSMsql_snapshotrst commands are specified,
there may be no change in difference copy operation for a specified time. You can
determine when to terminate the wait process in this case.
A value as a time limit is determined for second of the -limit second option of the
iSMrc_wait command.
In second, specify a value in second.
If the RPL_ENDWATCHDEV is not specified, the default is unlimited wait.
•
••
• Wait process message output
Determine whether to output a wait process message when the -wait option of
iSMrc_replicate, iSMrc_separate, iSMrc_restore,
iSMsql_snapshotbkup, and iSMsql_snapshotrst commands are specified or
when iSMrc_wait command is executed.
RPL_WAITMSG=USE
Outputs a wait process message. (Default)
RPL_WAITMSG=UNUSE
Does not output a wait process message.
[CHECK] section
Specifies restriction on operating with a disk.
•
••
• The number of partitions
Specifies restriction on the number of partitions.
A disk containing only one partition or only one logical volume is called single partition.
A disk containing two or more partitions or logical volumes is called multiple partitions.
PARTITION=SINGLE
Enables the command only for single partition (default).
PARTITION=MULTI
Enables the command for multiple partitions.
To ensure data consistency for all the partitions on the disk, be very careful in executing
the command.
[VOLLIST] section
Specifies operations when the command regarding OS type of the volume is issued.
•
••
• OS type of volume
RPLPLATFORM=“”
To Next Page
Loading...
