NEC Storage Manager - Page 32

Chapter 2 Command Reference
27
MV:/dev/rdsk/c0t1d1 disk101 NX
RV:/dev/rdsk/c0t2d1 disk102 NX
#
 The end messages are displayed in the order Replicate commands terminate.
(2) The command is executed by specifying a volume group that consists of two logical
volumes, /dev/rdsk/c1t1d0 and /dev/rdsk/c1t1d1, for an MV
(Individual specification)
# iSMrc_replicate -mv /dev/vg100 -mvflg vg -rv /dev/rdsk/c2t0d1
/dev/rdsk/c2t0d2 -rvflg sfn -wait 2
Replicate Start 2000/10/10 09:11:23
MV:/dev/rdsk/c1t1d0 disk001 NX
RV:/dev/rdsk/c2t0d1 disk221 NX
Replicate Start 2000/10/10 09:11:23
MV:/dev/rdsk/c1t1d1 disk002 NX
RV:/dev/rdsk/c2t0d2 disk222 NX
Replicating.....
Replicate Normal End 2000/10/10 09:16:12
MV:/dev/rdsk/c1t1d0 disk001 NX
RV:/dev/rdsk/c2t0d1 disk221 NX
Replicate Normal End 2000/10/10 09:16:35
MV:/dev/rdsk/c1t1d1 disk002 NX
RV:/dev/rdsk/c2t0d2 disk222 NX
#
[ NOTES ]
• The target MV is recognized by Replication Control as the Replication target disk.
• The target MV and RV are paired.
• The activity state of the target pair is Separate.
• The Semi-Sync copy mode cannot be specified for pairs set in the same disk array. The
Semi-Sync copy mode can be specified only for pairs set in different disk arrays.
• The disk array where the specified MV and RV are stored is not in the freeze state.
• The pair of the specified MV and the paired RV pair are not in the Restore state.
• The activity state of the pair of the specified MV and the paired upper MV is Separate.
• The activity state of the pair of the specified RV and the paired lower RV is Separate.
• RV is unmounted from the host.