Chapter 2 Command Reference
28
The following notes apply to the case when joint operation with the replication management is not
performed (the I/O issuance to disk arrays is directly controlled via FC).
• The target MV is registered in the Volume List.
• Specifying volume of a dynamic disk is not allowed.
• MV is a disk array under control of the self host.
• A Volume List is not being created.
• When specifying the combination of a volume group or a disk group with a special file name
(logical disk name), for an MV(RV), specify the same number of logical volumes that
constitute a volume group or a disk group on the specified special file name (logical disk name)
side. In this case, copying is performed in the specified order.
• To specify a volume group, the target volume group must be active.
• To specify a disk group, the target disk group must be active.
• The iSM special file is not being created (the UNIX system HP-UX version only).
[ RETURN VALUE ]
0: Operation for all the paired volumes terminated normally.
1: Operation for all the paired volumes terminated abnormally.
2: Operation for some paired volumes terminated abnormally.
3: The command terminated abnormally because all or some of the paired volumes were already
in Replicate State.
[ ERRORS ]
This command terminates abnormally in the following cases.
• A parameter is invalid.
• The instruction fails due to a disk array error.
To Next Page
Loading...
