Chapter 2 Command Reference
41
-wait [second] | -nowait Specify whether to wait for completion of Restore.
If -wait is specified, it waits until difference reflection
of MV/RV is complete.
It also monitors process state in a certain time interval.
The monitoring time interval is 5 seconds. If a value is
specified in second, the monitoring time interval of the
disk array becomes the specified value. The unit is
second, and the available range is from 1 through 30
seconds (integer). This value can be changed in the
replication operation option setting file on the Windows
system and in the environment variable on the UNIX
system. For details, refer to Chapter 3 “Operation
Settings”.
If this argument is omitted, the operation is the same as
the operation when -nowait is specified.
-mode operation_mode Specify an operation mode for RV at execution of
Restore.
One of the following can be specified for
operation_mode:
update: Performs restoration while reflecting the
updated data of the MV into the RV.
When the restoration is completed, the state
changes to Sync State (rst/sync).
protect: Performs restoration without reflecting the
updated data of the MV into the RV.
When the restoration is completed, Separate
is automatically executed and then the state
changes to Separated State.
default: This value can be changed in the replication
operation option setting file on the
Windows system and in the environment
variable on the UNIX system. For details,
refer to Chapter 3 “Operation Settings”.
If this argument is omitted, the system performs the same
operation as when default is selected.
To Next Page
Loading...
