Chapter 2 Command Reference
61
-rv volume Specify a volume of RV.
For information about the volume and volume types, refer
to 1.2 “Volume Types”.
-rvflg rv_flg Specify the type of the volume specified for -rv.
This argument must be specified if -rv is specified.
For information about the volume and volume types, refer
to 1.2 “Volume Types”.
-cond condition Specify a wait end condition.
One of the following can be specified for condition.
This argument must always be specified.
sync Waits for Sync State (rpl/sync) or Sync State
(rst/sync).
sep Waits for Separated State (separated).
-interval interval_time Specify an interval (in seconds) at which the state of
paired volumes is to be monitored.
This value can be changed in the replication operation
option setting file on the Windows system and in the
environment variable on the UNIX system. For details,
refer to Chapter 3 “Operation Settings”.
-limit limit_time Specify a wait time limit.
Either of the following can be specified for
limit_time.
numeric-value Waits until the specified time elapses
since the wait starts. A value 0 to
86,400 seconds (integer) can be
specified.
nolim Unlimited wait
If the end condition specified for the -cond option is not
satisfied before the specified time passes after the wait
starts, the wait is discontinued and the command
terminates abnormally.
This value can be changed in the replication operation
option setting file on the Windows system and in the
environment variable on the UNIX system. For details,
refer to Chapter 3 “Operation Settings”.
The default is unlimited wait.
To Next Page
Loading...
