NEC Storage Manager - Page 78

Chapter 2 Command Reference
73
is displayed. The <State> shows “Replicate”, “Restore”, “Separate”,
“Fault” (for fault), or “Forced Separate” (for Forced Separate). When “Fault” or
“Forced Separate” is displayed, the End Time does not appear.
• Separate Diff
Indicates the amount of copy difference in the Separate state in kilobyte.
• Copy Diff
Indicates the amount of copy difference in the Replicate or Restore state in kilobyte.
• RV Access
Indicates the access restrictions for RV.
rw Read/Write Permit (Read/Write are allowed)
ro ReadOnly (Only Read is allowed)
nr NotReady (Access is not available)
• Previous Active
Operation state before the state transition
If the pair of volumes enters the Separated State after Sync State when Restore with RV
protection is executed, the following is displayed as the pair’s operation state before the state
transition:
rst/sync (protect) Completion of Restore with RV protection specified
On the UNIX system
The state of the paired volumes is displayed.
#iSMrc_query -mv mv_special_file_name -mvflg sfn -rv
rv_special_file_name -rvflg sfn
MV: Special File mv_special_file_name
LD Name mv_ld_name
Type mv_type
RV: Special File rv_special_file_name
LD Name rv_ld_name
Type rv_type
Activity State aaaaaaaa
Sync State bbbbbbbb
Copy Control State cccccccc
<state> Start Time YYYY/MM/DD hh:mm:ss
<state> End Time YYYY/MM/DD hh:mm:ss
Separate Diff ddddddddKB
Copy Diff eeeeeeeeKB
RV Access ff
Previous Active gggggggg
#