NEC UNIVERGE NEAX 2000 IPS - Page 339

Chapter 16 Wireless System
UNIVERGE NEAX 2000 IPS Request For Proposal (RFP) Reference Guide Page 16-17
Issue 6
WCS Required Equipment (Cont.)
EQUIPMENT DESCRIPTION QTY REMARKS
• 10BASE-T Cable
(TIA/EIA category
3 or larger)
• 100BASE-TX
Cable (TIA/EIA
category 5)
10BASE-T/100BASE-TX Cable
between ETHER card and Ethernet
Cable Length:
Maximum 100 m (328 ft.)
As required
Router As required
PN-AP00-B (DBM) Roaming Data Base Module card 1
For Q931a Roaming
over IP Trunk
(Virtual IPT) Note
PN-IPTB (IPT) IP Trunk card 1-8
PN-4VCTI (4VCT) 4-channel CODEC card 1-32
IPTRK BUS CA Set of 3 BUS Cables between IPT and
4VCT cards
Length: 0.1 m (0.33 ft.)
1-32 sets
• 10BASE-T Cable
(TIA/EIA category
3 or larger)
• 100BASE-TX
Cable (TIA/EIA
category 5)
10BASE-T/100BASE-TX Cable
between IPT card and Ethernet
Cable Length:
Maximum 100 m (328 ft.)
As required
Router As required
PN-AP00-B (DBM) Roaming Data Base Module card 1
For Q931a Roaming
over IP Trunk
(Physical IPT)Note
PZ-M606-A (ETHER) Ethernet Control Card 1
• 10BASE-T Cable
(TIA/EIA category
3 or larger)
• 100BASE-TX
Cable (TIA/EIA
category 5)
10BASE-T/100BASE-TX Cable
between ETHER card and Ethernet
Cable length:
Maximum 100 m (328 ft.)
1
For Short Message
Notification (OAI)
Note: The SPN-AP00B DBM-C is required when accommodating 257 or more PSs.