NEC Univerge SV8100 - Installation of IP Terminals; Auto Configuration

Document No. SIB 244 Page 28 of 52 1
st
July 2008
NEC Australia Pty Ltd shall not be liable for any direct, indirect, consequential or incidental damages about the use of the information included in this document.
The information in this technical documentation is advisory in nature and is subject to change. NEC may make improvements and changes in the products
described in this documentation without notice. Contents of this document are subject to change without prior notice at the discretion of NEC Australia Pty Ltd.
This document has been prepared for use by employees and dealers of NEC Australia Pty Ltd and may not be reproduced without prior written approval of NEC
Australia Pty Ltd.
Installation of IP Terminals

ImportantNote

Donotassignanyofthefollowingfeaturestooperateconcurrentlyacrossmorethan16DT700IPterminals.
• InternalPaging
• BGM
• Doorphone

AutoConfiguration

SV8100 DHCP FTP
Configuration
File

Requiredequipment:

• IPphonemanager
FreesoftwareavailablefordownloadonNEC’swebsite.
ThissoftwarewillbeusedtocreatetheconfigfilefortheIPterminals.
• FTPserver
FreesoftwareavailableontheWEB.
• DHCPServer
ThisDHCPserverhastosupporttheabilitytodefine
a“VendorClass”.TheDHCPservermust
alsobeabletodefine“OptionCodes”.

ProcessOverview:

1. UsetheAutoCon figurationApplication tocreateaterminalconfigurationfilewithcorresponding
networkandtelephonydataparametersthatareneededtoconnecttheDT700IPTerminaltothe
TelephonySwitch.ThiscreatedAutoConfiguraiton
fileneedstobeloadedontoanetworkaccessible
PC/ServerwithaFTPserverrunning.

2. PlugtheDT700intothelocalnetwork(FactoryValueSettings).

3. LocalDHCPserverwillprovideVendorSpecificOptionsfortheDT700.

4. TheDT700willuseDHCPVendorSpecificOptionstocommunicate
withlocalFTPServer.

5. TheDT700willdownloadthecreatedAutoConfigfilefromtheFTPServer.

6. TheDT700willinitializewithitsnewdownloadedconfigurationandconnect totheTelephonySwitch.