NEC V302X - Powering Off the Projector

30
English ...
Installation
Powering Off the Projector
1. Press the “POWER OFF” button on the remote control or the
button on the control panel to turn off the projector lamp,
you will see a message as below on the on-screen display.
ARE YOU SURE
YES
NO
POWER OFF
2. Press the “POWER OFF” button again to conrm.
3. Disconnect the power cord from the electrical outlet and the
projector. If you disconnect the power cord while viewing
the picture and connect the power cord again, wait for at
least one second until you connect the power cord again.
While the POWER
LED indicator is blink-
ing green in short
cycles, the power
cannot be turned off
by using the power
button.