9
6. Hold the thread tail securely in one hand.
7. Step on the foot control to start winding
the bobbin.
8. After the bobbin has wound a few rounds,
stop the machine and cut the thread near
the hole of the bobbin. Continue lling
the bobbin until it is full. Once the bobbin
is full, it rotates slowly. Release the foot
control to stop the machine, then push the
bobbin winder spindle to the left.
9. Cut the thread and then remove the
bobbin.
Note
When the bobbin winder spindle is pushed
to the right position, it’s in "bobbin winding"
mode and the machine is not allowed to
sew and the handwheel will not be able
to turn. To start sewing, push the bobbin
winder spindle back to the left.
Note
Use a bobbin that has been correctly
wound with thread, otherwise the needle
may break or the thread tension will be
incorrect.
To Next Page
Loading...
