Necchi K121A - Starting to Sew

23
Starting to sew
2. Turn the handwheel towards you (counter-
clockwise) to bring the needle to highest
position.
3. Raise the presser foot lifter.
Turn the pattern selection dial to select a
stitch.
4. Place the fabric under the presser foot,
pass the thread under the presser foot,
and then pull out about 10cm of thread
toward the rear of the machine.
1
10cm
5. Turn the handwheel toward you (counter-
clockwise) to lower the needle into the
fabric at the beginning of the stitching.
Make sure you follow the needle/fabric/thread combinations (Page 16) and use the
suggested presser foot before sewing.
6. Lower the presser foot lifter.
1. Turn the power switch to on ("I").
ON
OFF
1