Necchi Q421A - Free Motion Darning, Embroidery and Monogramming; Preparation for Embroidering and Monogramming

40
v
Preparation for embroidering
and monogramming
* Embroidery hoop is not included with the
machine.
Move the drop feed lever to lower the feed
dogs.
1
Lowered position
Free motion darning, embroidery and
monogramming
Remove the presser foot and the presser foot
holder.
Draw the desired lettering or design on the
surface of the fabric.
Stretch the fabric between the embroidery
KRRSDV¿UPO\DVSRVVLEOH
Place the fabric under the needle. Make sure
the presser foot bar is down to its lowest
position.
Turn the handwheel towards you to bring up
the bobbin thread through the fabric. Sew a
few securing stitches at the starting point.
+ROGWKHKRRSZLWKWKXPEDQGIRUH¿QJHURI
both hands while pressing the material with
WKHPLGGOHDQGWKLUG¿QJHUDQGVXSSRUWLQJWKH
RXWVLGHRIWKHKRRSZLWK\RXUVPDOO¿QJHU
n
Attention
.HHS¿QJHUVDZD\IURPPRYLQJSDUWV
especially needles.
1
1
Note
:KHQ\RX¿QLVKWKHZRUNPRYHWKHGURS
feed lever to raise the feed dogs.
1
Raised position
3.5