Date: 21-03-2017 Version 8.0 Document no.: 5278210
This information is furnished for guidance, and with no guarantee as to its accuracy or completeness; its publication conveys no license under any patent or other right, nor does
the publisher assume liability for any consequence of its use; specifications and availability of goods mentioned in it are subject to change without notice; it is not to be
reproduced in any way, in whole or in part, without the written consent of the publisher.
© Nedap N.V., P.O. Box 103, NL-7140 AC GROENLO, The Netherlands
1. General
The Invexs 190 reader series is capable of reading (simultaneously) Nedap,
Mifare and DESFire credentials due to its dual reader technology. The
I
nvexs 190 is designed to be used on door pillars (mullion) and suitable for
outside and inside use. A model with keypad is also available. The Invexs
output can be set to either Wiegand, XS RF modulation or RS485 protocol
(plain or encrypted). Functionality and output are determined by the
configuration of the Invexs reader. The configuration is defined using the
programm AEreco, and deployed by the configuration card or via AEmon
.
(Mor
e information about configurations can be found in Convexs Invexs
Installation Manual). Three LEDs (red, green, blue) and beeper are included.
LEDs around the keypad ciphers light up only in case a PIN code is
requested. The pigtail cable can be lead directly backwards or when using
the additional spacer (art. nr . 9949887) to the top or bottom.
2. Dimensions
3. Mounting Procedure Invexs
For mounting the Invexs 190, the mounting plate must be placed on the wall
first. For removing the mounting plate from the Invexs 190, unscrew the
s
crew (Torx, M5) at the bottom of the Invexs and push the Invexs 190
slightly up . The plate can be mounted using the 4 holes. Place the cable to
the correct position and replace the Invexs 190.
Invexs 190 Readers Mifare Nedap dual technology mullion readers
Un screw
Push up
2
1
Mounting
plate
1
191
30
10 x 0.14
Shield
32
155
12
40
14.5
50
4 x 5
75
Dimensions: 191 x 50 x 30 mm.
4 mounting holes available at 32 x 155 mm
Cable pigtail: 10 x 0,14 mm shielded, 3m
Optional spacer (max thickness 10 mm) is
available for other cable outlet (top or
bottom)
01
02
01
02
To Next Page
