66 - EN
The device is easy to remove from its holder for baery change.
2. Make sure that the screen is at least +15 °C, as
the adhesive pads do not work correctly at lower
temperatures. If necessary, warm up the windscreen
using the vehicle’s fan or (very carefully) with a hair-dryer.
3. Clean the inside of the windscreen in the installaon
area with glass cleaner or damp cloth. Wipe the glass dry
carefully. You may use marking tape on the outside of
the windscreen to help nding the best locaon.
4. Remove the protecve lm from the adhesive pads and
press the parking disc rmly against the windscreen for
about 30 seconds. Do not press against the middle of the
back. Then check from the outside that both adhesive pads
are stuck to the screen well.
To Next Page
Loading...
