PERICALM™ Instruction Manual - GB
14
Care & Maintenance
Control Unit:
•
Wipe the surface after use with a damp cloth or antiseptic wipe
•
Do not use cleaning sprays or alcohol based cleaning solutions
Battery:
• To change the battery, open the battery door on the rear of the control
unit by pressing down on the raised rib pattern just below the belt clip.
Lift the battery out of the compartment. This is very easy and can be done
by the user.
•
Check periodically for any discharge from the battery
•
Remove battery completely from unit if not in use for any extended period
of time (typically one week)
•
Low battery indicator of 6.9 volts shown on LCD display. When flashing
change battery for a new one
•
Preferably use a PP3 alkaline battery
Lead Wires:
•
The lead wires should be handled carefully and never stretched, as this can
cause the stimulation to function below normal standards or not at all
•
Examine lead wires before each treatment for loose connections or damage
•
Avoid twisting the lead wires
•
Wipe lead wires after use with a damp cloth or antiseptic wipe
•
Store the lead wires carefully after each use
Self-Adhesive Electrodes:
•
Check the short connectors have not become separated from the electrodes
•
Replace electrodes onto plastic film after use. If they drop onto the floor
debris will adhere to conductive gel rendering the electrodes ineffective
Vaginal / Anal Probes
•
Check the connectors have not become separated from the probe
•
Before & after use always wash it in warm soapy water, rinse and dry and
carefully store
•
Never let anyone else use your electrode
•
Follow all instructions provided
with the electrode
Caution: Static electricity may damage this product
NOTE: Only Patterson Medical or appointed distributors/importers are
approved to undertake servicing.
To Next Page
Loading...
