Neets SB1 - Audio Output Settings

Page 16 of 16
Audio input settings
Audio input settings are used to adjust settings for Wake-on-signal settings.
All commands start with: NEUNIT=1,SETTINGS=INPUT, followed by the command in <A>,
the value after the equal sign must be replaced with the value in <X> or a question mark,
all commands must end with a \CR.
Description <A> <X> Default <X> R/W
Set wake-on-signal function
on or off. This applies for all
inputs
WOS=<X> ON or OFF OFF R/W
Example of use:
NEUNIT=1,SETTINGS=INPUT,WOS=ON\CR <- Set wake-on-signal function on.
NEUNIT=1,SETTINGS=INPUT,WOS=OFF\CR <- Set wake-on-signal function off.
NEUNIT=1,SETTINGS=INPUT,WOS=?\CR <- Query the wake-on-signal setting.
Audio output settings
Audio output settings adjust Sound Bar equalizer output parameters.
All commands start with: NEUNIT=1,SETTINGS=OUTPUT, followed by the command in <A>,
the value after the equal sign must be replaced with the value in <X> or a question mark,
all commands must end with a \CR
Description <A> <X> Default <X> R/W
Select equalizer preset EQ=<X> 1 – 3 1 R/W
Example of use:
NEUNIT=1,SETTINGS=OUTPUT,EQ=1\CR <- Select equalizer preset 1.
NEUNIT=1,SETTINGS=OUTPUT,EQ=2\CR <- Select equalizer preset 2.
NEUNIT=1,SETTINGS=OUTPUT,EQ=3\CR <- Select equalizer preset 3.
NEUNIT=1,SETTINGS=OUTPUT,EQ=?\CR <- Query the equalizer preset.