Neets SB1 - Specifications

Page 6 of 16
Specications
Neets Sound Bar SB1
Audio output
Output power 4 x 20 Wrms
THD+N < 0.1 % @ 1 W
Woofer 2 x 4” dual magnet,
sandwich membrane
w/rubber surround
Tweeter 2 x 1” soft dome
Frequency Response 50 Hz - 20 kHz +/- 3
dB
Maximum SPL 106 dBA
Unbalanced audio input
Number of inputs 1 x stereo input
Max input level 1 Vrms
Input impedance < 20 k Ohm
Wake-on-signal Yes
Connector 2 RCA female
Balanced audio input
Number of inputs 1 x stereo input
Max input level 2 Vrms
Input impedance < 100 k Ohm
Wake-on-signal Yes
Connector 1 x 5 pin screw block
Digital audio input
Interface standard IEC 60958
AC-3, DTS decoding Not supported
Bit depth 16/24 bit
Sample rate 32/44.1/48/96/192 kHz
Wake-on-signal Yes
Connector 1 TOSLINK female
Approvals
IEC/EN 61000-6-1
IEC/EN 61000-6-2
RS-232
Ports 1 x bidirectional
Baud rate 19200 bit/sec
Data bits 8
Parity None
Stop bits 1
Connector 1 x 3 pin screw block
Power input
Input voltage 24 VDC
Max power usage 50 W
Standby power usage < 0.5 W
Connector 5,5 mm DC plug
Power adaptor
Line voltage 100 VAC – 240 VAC
Line frequency 50 Hz – 60 Hz
Output voltage 24V
Max output current 2.5A
Max power usage 70 Watt
General
Enclosure Wood (MDF)
Enclosure finish Mate black vinyl
Front grille Textile covered MDF
Width 1018 mm / 40.1 inch
Depth 75 mm / 2.95 inch
Depth w. wall bracket 81mm / 3.18 inch
Height 130 mm / 5.1 inch
Weight 4.5 Kg
Shipping width 1120 mm / 44.1 inch
Shipping depth 150 mm / 5.9 Inch
Shipping height 200 mm / 7.8 Inch
Shipping weight 6.5 Kg
Storage temperature -20 °C to 50 °C
Storage moisture Non condensing