NEFF B5ACM7HH0B - Page 26

en Appliance door
26
4.
Push down on the intermediate pane in the area of
, and carefully lift the retainer until you are able
to pull it out.
5.
Lift the first and second intermediate panes from be-
low and remove them in the direction of the arrow
⁠.
6.
Remove the spacers and seals for cleaning, if
required.
7.
WARNING‒Risk of injury!
Scratched glass in the appliance door may develop
into a crack.
▶
Do not use glass scrapers, sharp or abrasive
cleaning aids, or harsh cleaning products.
Clean the door panes on both sides with glass
cleaner and a soft cloth.
8.
Dry the door panes and refit them.
→"Fitting the door panes", Page26
18.4 Fitting the door panes
WARNING‒Risk of injury!
If a door pane or appliance door has not been installed
correctly, this is dangerous.
▶
Make sure that all of the door panes and the appli-
ance door have been correctly fitted before you
switch the appliance back on again.
1.
Tip:When fitting the door panes, make sure that
they are in the original order.
Insert the intermediate pane so that the arrow on
the right-hand side is pointing upwards.
2.
Check the fit of the four spacers and two seals.
‒ Place the spacers on the centre of the lines ⁠ ⁠.
‒ Secure the seals at the corners ⁠.
3.
Insert the intermediate pane with spacers and seals
in the direction of the arrow ⁠.
The arrow on the intermediate pane must line up
with the arrow on the frame ⁠.
4.
Insert the second intermediate pane without the
spacers and seals, and slide it in the direction of the
arrow until it is inserted in the frame ⁠.
The arrow on the intermediate pane must line up
with the arrow on the frame ⁠.