8
Removing metal grease filter
1. Open the lock and fold down the metal grease filter. While
doing this, place your other hand under the metal grease
filter.
2. Take the metal grease filter out of the holder.
Notes
■ Grease may accumulate in the bottom of the metal grease
filter.
■ Hold the metal grease filter level to prevent grease from
dripping out.
3. Clean the metal grease filter.
Cleaning the metal mesh grease filters
: Risk of fire!
Grease deposits in the grease filter may catch fire.
Clean the grease filter at least every 2 months.
Never operate the appliance without the grease filter.
Notes
■ Do not use any aggressive, acidic or alkaline cleaning
agents.
■ When cleaning the metal mesh grease filters, also clean the
holder for the metal mesh grease filters in the appliance
using a damp cloth.
■ The metal mesh grease filters can be cleaned in the
dishwasher or by hand.
In the dishwasher:
Note: If the metal mesh grease filters are cleaned in the
dishwasher, slight discolouration may occur. This has no effect
on the function of the metal mesh grease filters.
■ Do not clean heavily soiled metal mesh grease filters together
with utensils.
■ Place the metal mesh grease filters loosely in the dishwasher.
The metal mesh grease filters must not be wedged in.
By hand:
Note: You can use a special grease solvent for stubborn dirt. It
can be ordered via the Online Shop.
■ Soak the metal mesh grease filters in a hot soapy solution.
■ Clean the filters with a brush and then rinse them thoroughly.
■ Leave the metal mesh grease filters to drain.
Installing the metal mesh grease filter
1. Insert the metal mesh grease filter.
While doing this, place the other hand under the metal mesh
grease filter.
2. Fold the metal mesh grease filter upwards, locking it in place.
Trouble shooting
Malfunctions often have simple explanations. Please read the
following notes before calling the after-sales service.
: Risk of electric shock!
Incorrect repairs are dangerous. Repairs may only be carried
out and damaged power cables replaced by one of our trained
after-sales technicians. If the appliance is defective, unplug the
appliance from the mains or switch off the circuit breaker in the
fuse box. Contact the after-sales service.
LED lights
Defective LED lights must only be replaced by the
manufacturer, their customer service department or a licensed
technician (electrician).
Fault table
--------
Fault Possible cause Solution
The appliance does not work The plug is not plugged into the mains Connect the appliance to the power
supply
Power cut Check whether other kitchen appliances
are working
The fuse is faulty Check in the fuse box to make sure that
the fuse for the appliance is in working
order
The lighting does not work The bulbs are faulty Call the after-sales service
”ªª flashes
The metal grease filter is saturated Clean the filter, see the Cleaning and
maintenance section
’ªª flashes
The activated charcoal filter is saturated Replace the filter; see the "CleanAir air
recirculation module" printed supple-
ment
To Next Page
Loading...
