Appliance door en
25
6.
Remove the inner panel upwards at an angle and
set it down carefully on a flat surface.
7.
Open the left- and right-hand metal strip in the direc-
tion of the arrow
.
8.
Pull the first and second intermediate panels up-
wards and out at an angle, and set them down care-
fully on a flat surface.
9.
WARNING‒Risk of injury!
Scratched glass in the appliance door may develop
into a crack.
▶ Do not use any harsh or abrasive cleaners or
sharp metal scrapers to clean the glass on the
oven door, as they may scratch the surface.
Clean the removed door panels on both sides with
glass cleaner and a soft cloth.
10.
Clean the appliance door.
→"Suitable cleaning agents", Page19
11.
Note:While the cleaning function is running, the
frame on the inside of the appliance door or other
parts of the door that are made of stainless steel
become discoloured. This discolouration does not
compromise the functionality of the appliance. The
discolouration can be removed using a stainless
steel cleaner.
Dry the door panels and refit them.
→"Fitting the door panes", Page25
21.4 Fitting the door panes
Note:
Ensure that the arrow is on the top left on the interme-
diate panes.
1.
Slide the first intermediate pane into the lowest re-
tainer and fit it at the top.
2.
Note:The intermediate pane is automatically posi-
tioned by the rotational movement of the spacer.
Slide the second intermediate pane into the central
retainer and fit it at the top.
3.
Close the metal strip on the left and right .
To Next Page
Loading...
Need help?
General