English Deutsch Français Español Italiano
日本語
15
If you plan to assemble your NEILPRYDE bicycle with Shimano electronic gear system, please note that a qualified bicycle mechanic should always do the assembly.
NEILPRYDE bicycles have been designed to work with Shimano mechanical groupsets for road and time trial bicycles as well as Shimano Dura Ace 9070 (Di2) and Shimano Ultegra 6770
(Di2) & 6870 (Di2).
NEILPRYDE frames are not designed to be compatible with Shimano Dura Ace 7970 (Di2) system or Campagnolo EPS system.
Any modifications to the frame to suit installation of groupsets not compatible with Shimano Dura Ace 9070 (Di2) and Shimano Ultegra 6770 (Di2) & 6870 (Di2) will void the warranty.
ELECTRONIC GEAR SYSTEM COMPATIBILITY
BAYAMO DI2 COMPATIBLE INSERTS
Refers to the cover plate, which should be fitted when using a Shimano Di2 electronic gear system.
Please ensure a qualified bicycle mechanic does the installation/maintenance.
The maximum torque for the bolt is 3Nm.
Refers to the insert that should be fitted when using a Shimano Di2 electronic gear system.
Slot no.1 is for Shimano electronic system wire entry.
Hole no.2 is for rear brake cable housing.
Please ensure a qualified bicycle mechanic does the installation/maintenance.
The maximum torque for the bolt is 2Nm.
To Next Page