Nelsen Corporation C Series User Manual

-11-
C-Series 1" & 1-1/4" WS1 Manual
Installer Display Settings
STEP 1i
Press NEXT and p
simultaneously for
3 seconds.
STEP 2i
Hardness: Set
the amount of
hardness in grains
of hardness as
calcium carbonate
per gallon using
the porq
buttons. The default is 20 with value ranges from 1 to 150
in 1 grain increments.
Note: The grains per gallon can be increased if soluble
iron needs to be reduced. This display will show “–
nA–” if “FILTER” is selected in OEM Filter Set-up or
if ‘AUTO’ is not selected in OEM Softener Set-up.
Press NEXT to go to Step 3i.
Press REGEN to exit Installer Display Settings.
STEP 4i
Next
Regeneration
Time (hour): Set
the hour of day for
regeneration using
porq buttons.
AM/PM toggles
after 12. The default time is 2:00 a.m. This display will
show “REGEN on 0 GAL” if “on 0” is selected in the
OEM Setup.
Press NEXT to go to step 5i.
Press REGEN to return to previous step.
STEP 5i
Next
Regeneration
Time (minutes):
Set the minutes
of day for
regeneration using
porq buttons.
This display will not be shown if “on 0” is selected in the
OEM Setup.
Press NEXT to exit Installer Display Settings.
Press REGEN to return to previous step.
To initiate a manual regeneration immediately, press and
hold the “REGEN” button for three seconds. The system
will begin to regenerate immediately. The control valve
may be stepped through the various regeneration cycles
by pressing the “REGEN” button.
STEP 3i
Day Override:
When gallon
capacity is set to
off, Day Override
sets the number
of days between
regenerations.
When gallon capacity is set to AUTO or to a number, Day
Override sets the maximum number of days between
regenerations.
If value set to “oFF” regeneration initiation is based solely
on gallons used. If value is set as a number (allowable
range from 1 to 28) a regeneration initiation will be called
for on that day even if sufficient number of gallons were
not used to call for a regeneration. Set Day Override using
porq buttons:
• number of days between regeneration (1 to 28); or
• “oFF”.
See Setting Options Table for more detail on setup.
Press NEXT to go to Step 4i.
Press REGEN to return to previous step.
Return to Normal Mode

Nelsen Corporation C Series Specifications

General

Brand	Nelsen Corporation
Model	C Series
Category	Control Unit
Language	English