Power Connection
Before connection, check whether the Mailing System is suitable for the local AC power
voltage; refer to the type plates at the back of each system component.
THIS SYSTEM MUST BE GROUNDED
• Only connect the power plug to an outlet provided with a
protective ground contact.
• To reduce the risk of fire, use only the power cord supplied
with the Mailing System.
• Do not use ground adaptors.
• Do not use this product on a wet floor or near water.
• In case of liquid spillage, disconnect the power cord from the
outlet and proceed with cleaning.
• Use an outlet located near the system that is easily accessible. As the power supply
cord is the system disconnecting device, do not route the power cord between pieces
of furniture or over sharp edges.
• Avoid using outlets controlled by wall switches or shared by other equipment.
• Make sure there is no strain on the power supply cord.
Disconnecting your Mailing System
How to Disconnect your Mailing System
First switch your Mailing System to OFF mode.
Only unplug the power cord when the Mailing System is OFF or in
Sleep mode to avoid keeping the ink cartridge in an unprotected
position where the ink may dry out and become unusable.
1.
2. Unplug the power cord from the wall outlet.
3. Unplug the LAN cable from their sockets as they may still be energized.
2
| Page 2 | Mar-09-2016 05:22 | Read this First
To Next Page
Loading...
Need help?
General
