To Next PageTo Next PageHow to troubleshoot a Neptun Water Pump that won't start?
If your Neptun Water Pump isn't starting, there are a couple of things to check. First, make sure the power supply is properly connected. Second, the floating switch might not be triggering; try raising its position.
What to do if Neptun Water Pump is not pumping water?
If your Neptun Water Pump isn't pumping water, consider these potential causes: a clogged intake sieve or a kinked discharge hose. Try cleaning the intake sieve with a water jet. Also, check the discharge hose and unkink it if necessary.
Why is the pumping rate of my Neptun Water Pump insufficient?
An insufficient pumping rate in your Neptun Water Pump can be due to a couple of reasons. The intake sieve might be clogged; try cleaning it. Also, heavily contaminated water with abrasive impurities can reduce performance, so you should clean the equipment and replace any worn parts.
Why does my Neptun NCSP-E 35 Water Pump switch off after running briefly?
If your Neptun Water Pump switches off soon after starting, it could be due to these reasons: excessive water contamination causing the motor circuit-breaker to activate, or the water temperature being too high, which also trips the motor circuit-breaker. To resolve this, unplug the power and clean the equipment and shaft. Also, ensure the water temperature doesn't exceed 35 °C.
What to do if Neptun NCSP-E 35 does not cut out?
If your Neptun Water Pump isn't cutting out, it might be because the floating switch cannot sink. Ensure the equipment is correctly placed on the shaft bottom.
General| Brand | Neptun |
|---|---|
| Model | NCSP-E 35 |
| Category | Water Pump |
| Language | English |
Details the components of the pump, including handle, floating switch, intake cage, and hose connection.
Lists the components included in the product packaging, such as the pump, hose connection, and manual.
Describes how to install the pump, either stationary with a rigid pipe or flexible hose.
Explains how to adjust the floating switch to set the automatic on/off levels for the pump.
Instructions for dismantling the lower part to clean the paddle wheel and housing.
States that there are no internal parts requiring additional maintenance.
Details the information needed when ordering replacement parts, including type, article, and part numbers.
