EasyManuals Logo
Home>Neptune Systems>Control Unit>AquaController Apex Classic

Neptune Systems AquaController Apex Classic User Manual

Neptune Systems AquaController Apex Classic
121 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #25 background imageLoading...
Page #25 background image
Apex Classic Setup and Programming Guide v2.2 Page 20
mail
If you don’t understand the debug messages please email the log to
support@neptunesys.com, and we’ll help you determine what is wrong.
This function can be used to send a test email to verify end-to-end operation of
all components needed to send email alarms.
Apex Display: System Email Setup Email test: push the Select
button to send a test message.
Web Interface: Configuration Network setup click the checkbox next
to Email test, press the Update Network Settings button to send a test
message.
CONFIGURING THE APEX TO BE ACCESSIBLE FROM THE
INTERNET
After configuring and verify the operation of the network interface, you can
configure your home network router so that the AquaController can be accessed
from the internet.
WARNING: Change the administrator user name and password of the
AquaController before enabling access to the AquaController Apex from the
Internet (see the section titled Configure the Apex Web Interface Administrator
Credentials for instruction). Do not leave the default user name and password
configured or you are exposing your system to unauthorized access.
Configure your router so that incoming port 80 TCP requests are forwarded to the
AquaController IP address on port 80. This configuration is usually done in the
router's virtual server setup menu, port forwarding, or the UPnP section. Consult
your router’s setup manual for details on setting up this access.
NOTE: On some routers (Linksys), you must enable UPnP or port forwarding at
the global level before port forwarding will work. A good resource to use to setup
your router’s port forwarding is www.portforward.com. This website has
instructions on setting up port forwarding for many different types of routers.
To access the AquaController Apex from the internet you need to know your WAN
IP address; the WAN IP address can be found by going to www.whatismyip.com
from a computer on your home network. Your WAN IP address is the address you

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Neptune Systems AquaController Apex Classic and is the answer not in the manual?

Neptune Systems AquaController Apex Classic Specifications

General IconGeneral
BrandNeptune Systems
ModelAquaController Apex Classic
CategoryControl Unit
LanguageEnglish