Neptune Systems AquaController Apex Classic

Apex Classic Setup and Programming Guide v2.2 Page 3
• Completely silent operation on the 6 solid state switched outlets (5 amps
max per outlet).
• Solid State outlets feature a soft-start mechanism for reduced pump wear.
• 2 Relay controlled outlets for higher power switching (each 10 amps max).
• 15 amp circuit breaker for overload protection.
• Built-in powered 6 port AquaBus hub to easily add accessory modules.
• High reliability direct wired connection to the AquaController Apex system
through the AquaBus.
• Powers the AquaController Apex Display, Apex Base Module and accessories
through the AquaBus.
• Active electrical current monitoring, power failure detection and logging
through the AquaController Apex.
• If communication failure occurs between the AquaController Apex system
and the EnergyBar 8 (cable is unplugged for example), each outlet can be
configured to revert to a user defined default setting or maintain the last
setting.
• Compact custom aluminum enclosure with 4 mounting holes (10.0" x 3.75"
x 1.8").
TABLE OF ACRONYMS
DHCP – Dynamic Host Configuration Protocol
DNS – Domain Name Service
IP – Internet Protocol
ISP – Internet Service Provider
ORP – Oxygen Reduction Potential
RSS – Really Simple Syndication
SMTP – Simple Mail Transfer Protocol
URL – Uniform Resource Locator
XML – eXtensible Markup Language
TYPICAL AQUACONTROLLER SYSTEM COMPONENTS
• Apex Base Module
• Apex Display Module
• Apex EnergyBar 8
• Apex Temperature Probe
• pH Probe (optional)
• ORP Probe (not supported on Apex Lite, optional on Apex)
• AquaBus Cable
• Ethernet cable