What to do if Neptune Conference System shows low RSSI during installation?
If you encounter a low RSSI value during installation, especially if the RSSI value is at the upper limit of the marginal range or is a failed RSSI, consider relocating the MIU (Metering and Interface Unit). Try moving it to a higher installation level, such as higher than 4 feet above ground level, or relocate the MIU near the corner of a house or building.
What to do if Neptune Conference System shows low RSSI values for existing installations?
If you observe low RSSI values in existing installations, check the RSSI values and try relocating the MIU to a better location. If the problem persists, it may be necessary to replace the MIU.
How to fix low RSSI in pit MIU installations of Neptune Conference System?
To address low RSSI in pit MIU installations: * Check the RSSI values and reorient the pit antenna. * Check the antenna connection to the MIU. * Replace the pit antenna if necessary. * If the issue continues, replace the MIU.
What to do if Neptune Conference System has invalid register reading or connection?
If you are experiencing an invalid register reading or connection, take the following steps: * Check the wiring connections, including terminal screws and Scotchloks, to ensure they are properly connected. * For non-prewired and potted registers, verify that the silicone is correctly applied. * If using a Rev. E or older register, confirm it is programmed in a three-wire RF format using a field programmer. * If the problem persists after these checks, consider replacing the register.
General| Brand | Neptune |
|---|---|
| Model | R450 |
| Category | Measuring Instruments |
| Language | English |
To Next Page
