t : +44 (0) 1793 427300 f : +44 (0) 1793 427399 e : info@neptune.com
www.neptune.com
6
4. Levelling
It is very important to ensure that all cabinets are level and true. Time spent levelling is critical to a successful kitchen t.
All base cabinets are supplied with height adjustable feet that can be used in two ways;
1. Using the supplied Allen key the adjustable feet can be turned from within the cabinet. (Drawers & hardware may need
to be removed for some cabinets, see section 10 for drawer removal) Turning the Allen Key socket clockwise will
extend the foot. (see Diagram 9)
2. The feet can also be adjusted directly by hand from the exterior of the cabinet. This is easiest if the cabinet is on its side
or back. (see Diagram 10)
The Process;
1. Place the cabinet as near to its nal location as possible.
2. Raise the entire cabinet & set height to 890mm from the oor at the lowest point in the room.
3. Continue to raise and lower each foot until the cabinet is completely level. This will need to be checked with a spirit
level as shown in diagram 9.
4. You may nd that you have to go back and forth between legs several times.
5. Levelling each cabinet fully is key to ensuring doors and drawers open and close freely throughout the life of the
kitchen.
Diagram 9. Diagram 10.
Diagram 11.
To Next Page
Loading...