t : +44 (0) 1793 427300 f : +44 (0) 1793 427399 e : info@neptune.com
www.neptune.com
1. Cornice should be tted to all wall cabinets and full height cabinets.
2. Sections should be joined using an equal mitre joint.
3. The cornice can be glued or screwed to the cabinet. The cabinet must be pre-driled before screwing the cornice, to
prevent the carcass wood splitting.
4. The cornice mitre joints should be xed with wood glue. Care should be taken to remove any excess adhesive.
Cornice
Diagram 7.
5
To make a feature of a particular kitchen cabinet it can be stepped out within a run. This is one of the unique features of a
Suolk Kitchen and allows for an individual kitchen design. This is often done with Sink cabinets but can be done using any
base cabinet.
To o-set a cabinet simply bring it forward and bring the adjoining cabinets to the walls of the o-set cabinet. This will mean
that the o-set cabinet is 25mm further from the wall, and the gap between cabinets is 12mm less.
12
25mm
3. Osetting
Diagram 8.
5
To Next Page
Loading...