▪
ha
▪
mcc
▪
mcc-2n
▪
mccip
▪
non-ha
b.
Confirm that the setting has changed:
ha-config show
Recable the system and reassign disks - ASA A150
To complete the replacement procedure and restore your system to full operation, you
must recable the storage, confirm disk reassignment, restore the NetApp Storage
Encryption configuration (if necessary), and install licenses for the new controller. You
must complete a series of tasks before restoring your system to full operation.
Step 1: Recable the system
Recable the controller module’s storage and network connections.
Steps
1. Recable the system.
2. Verify that the cabling is correct by using
Active IQ Config Advisor.
a. Download and install Config Advisor.
b. Enter the information for the target system, and then click Collect Data.
c. Click the Cabling tab, and then examine the output. Make sure that all disk shelves are displayed and
all disks appear in the output, correcting any cabling issues you find.
d. Check other cabling by clicking the appropriate tab, and then examining the output from Config Advisor.
Step 2: Reassign disks
If the storage system is in an HA pair, the system ID of the new controller module is automatically assigned to
the disks when the giveback occurs at the end of the procedure. In a stand-alone system, you must manually
reassign the ID to the disks.
You must use the correct procedure for your configuration:
Controller redundancy Then use this procedure…
HA pair Verifying the system ID change on an HA system
Stand-alone Manually reassigning the system ID on a stand-alone system in ONTAP
Two-node MetroCluster
configuration
Manually reassigning the system ID on systems in a two-node
MetroCluster configuration
49
To Next Page
Loading...
