A component with a Failed status must be replaced.
If the second power supply canister in the shelf does not have Optimal status, do not
attempt to hot-swap the failed power supply. Instead, contact technical support for
assistance.
3. From the back of the storage array, look at the Attention LEDs to locate the power supply you need to
remove.
You must replace the power supply that has its Attention LED on.
◦
If the Power LED
is solid green, the power supply is functioning correctly. If it is Off, the power
supply failed, the AC switch is turned off, the AC power cord is not properly installed, or the AC power
cord input voltage is not within margin (there is a problem at the source end of the AC power cord).
If the Attention LED
is solid amber, the power supply or its integrated fan has a fault.
Step 2: Remove failed power supply
Remove a failed power supply so you can replace it with a new one.
Steps
1. Unpack the new power supply, and set it on a level surface near the drive shelf.
Save all packing materials for use when returning the failed power supply.
2. Turn off the power supply and disconnect the power cables:
a. Turn off the power switch on the power supply.
b. Open the power cord retainer, and then unplug the power cord from the power supply.
c. Unplug the power cord from the power source.
3. Squeeze the latch on the power supply cam handle, and then open the cam handle to fully release the
power supply from the mid plane.
36
To Next Page
Loading...
