Netatmo Thermostat User Manual

• Read these instructions carefully before starting the installation.
• The Netatmo Thermostat must be installed according to
applicable standards.
• Before any intervention, make sure power is turned off.
In the box
Warning
Warning!
Color Adhesives
3 AAA batteries 4 screws
4 screw anchors
(Mains adapter)*
1 USB cable
Thermostat Relay Boiler adapter
Mobile stand
* not used or optional in this setup
(Mounting Plate)*
Tape
230V
+
(Trim plate)*

Netatmo Thermostat Specifications

General

Interface	RF
Product color	Translucent, White
Memory function	No
Wi-Fi frequency	2.4 GHz
Wi-Fi standards	802.11b, 802.11g, Wi-Fi 4 (802.11n)
Smart thermostat	Yes
Security algorithms	WEP, WPA, WPA2-AES, WPA2-TKIP
Maximum indoor range	100 m
Units of measurement	°C
Temperature increment	0.5 °C
Temperature setpoint range	5 - 30 °C
Battery life	2 year(s)
Battery type	AAA
Power source	Battery
Maximum switching current	4 A
Maximum switching voltage	250 V
Number of batteries supported	3
Quantity	1
Cables included	USB
Mobile operating systems supported	Android 4.2, Android 4.2.1, Android 4.2.2, Android 4.3, Android 4.4, Android 5.0, Android 5.1, Android 6.0, Android 7.0, Android 7.1, Android 7.1.2, Android 8.0, Android 9.0, Windows Phone 8, Windows Phone 8.1, Windows Phone 9, iOS 10.0, iOS 11.0, iOS 11.4, iOS 12, iOS 9.0, iOS 9.1, iOS 9.2, iOS 9.3, iPadOS
Humidity sensor	-

Weight and Dimensions

Depth	22 mm
Width	83 mm
Weight	185 g