NetComm NF8AC User Manual

www.netcommwireless.com
NetComm Wireless NF8AC User Guide
47
Security
The NF8AC supports all encryptions within the 802.11 standard. The factory default is WPA2-PSK. The NF8AC also supports WPA,
WPA-PSK, WPA2, WPA2-PSK. You can also select to enable WPS mode.
Figure 40: Wireless - Security
The following parameters are available:
PARAMETER
DEFINITION
Enable WPS
Select to enable or disable the WPS function of the NF8AC.
Select SSID
Select the SSID to apply the security settings to.
Network Authentication
Select the Wireless security type to use with the wireless network.
WPA/WAPI passphrase
Enter the security key to use with the wireless network.
WPA Group Rekey Interval
Enter the group rekey interval. This should not need to change.
WPA/WAPI Encryption
Select the type of encryption to use on the wireless network.
WEP Encryption
Select to utilise WEP encryption on the wireless network connection.
Click Apply/Save to save the new wireless security configuration settings.
MAC Filter
MAC Filter allows you to add or remove the MAC Address of devices which will be allowed or denied access to the wireless
network. First use the Select SSID drop down list to select the wireless network you wish to configure, then select to either allow or
deny access to the MAC addresses listed.
Click Add to add a MAC Address Filter.

NetComm NF8AC Specifications

General

Brand	NetComm
Model	NF8AC
Category	Wireless Router
Language	English